Self-adhesive floor stickers are a new type of flooring material, which uses special adhesives, such as pressure-sensitive hot melt adhesives, which are environmentally friendly and have moderate viscosity. Self-adhesive floor stickers have the characteristics of strong bright surface, tough, non-slip, waterproof, suitable for cement, ceramic tile, terrazzo, wood floor and other ground. In addition, its assembly is simple, with a variety of methods such as I-word equivalent assembly and 369 equivalent assembly, and it can be easily done without a professional construction team.
However, self-adhesive floor stickers also have some disadvantages. First of all, its selection range is relatively small, currently the most are wood grain and carpet grain. Secondly, the glue of self-adhesive floor has a certain service life, suitable for short-term use, such as rental housing, facade, etc. At the same time, the construction requirements are also high, the ground must be smooth and clean, and the ground must be cleaned before laying. In addition, self-adhesive floor stickers are afraid of fire and are not flame retardant or chemical resistant.
When paving self-adhesive floor stickers, you need to follow the following steps:
If the ground is flawed or uneven, need to use the floor sandpaper or grinding machine to smooth, in order to achieve a smooth effect.
Select the appropriate paving position.
Spread the self-adhesive floor sticker on the ground, then use a tape measure and pencil to evenly mark the length and width to be cut, and cut the self-adhesive floor sticker. The width of the edge needs to be left when cutting, so that a certain gap can be left when fitting.
Place the cut self-adhesive floor sticker on the paving position, and then use ink line or pencil to draw the position and direction of the paving on the ground.
Remove the bottom paper of the self-adhesive floor sticker and stick it on the ground in the correct position. When sticking, keep a certain angle and press gently to make it completely fit with the ground. At the same time, pay attention to the gap of the fit. Be consistent.
During the bonding process, if it is found that the floor sticker is not well bonded or bubbles appear, it can be readjusted in time. At the same time, after the paving is completed, it is necessary to check again whether there is a good place to ensure the perfection of the paving.