anti-static pvc flooringanalysis of problems in the design:
Anti-static PVC floor fire rating should be in line with the "building interior decoration planning fire protection standards" requirements. The height of the anti-static PVC floor should be determined according to the requirements of use. The basic scale is 250mm. Wiring and air-conditioning gas tank: basic scale is 400mm. The detachable plates of the floor can be interchanged, and the manufacturing precision is high, which can ensure the airtightness of the floor space when used in the air-conditioning refrigerator. The ground pavement construction of anti-static machine room is the final stage of building decoration. The interior ceiling will eventually be laid. After the ceiling lamp, the vent also means the end. Clean the floor and lay the floor (with insulation cotton and pipe insulation cotton, lay the first groove).

The anti-static pvc floor has been laid on the cement mortar leveling pad. In order to reduce the height of the direct laying in the floor structure, the flat appearance, spray interface and cured concrete appearance required by the floor structure make the ground free of sand. The surface of the floor should be soft, non-slip, wear-resistant and anti-pollution.
Ground equipment must be grounded, otherwise it cannot play an anti-static role to clean the ground: the original bottom surface should be flat, the ground debris should be removed, clean with a shovel, no obvious unevenness. Locating line: According to the plane scale and equipment layout of the room, according to the modulus of the raised floor, formulate a laying plan and a reasonable laying method, and follow the following standards: If there is no control cabinet and other equipment in the room, when the ruler has a suitable movable board When the modulus, lay from inside to outside.
Anti-static pvc floor installation and laying tools: marble cutting saw, laser level, network laser scanner, blister level, tape measure, ink line, suction plate, nut adjustment handle, Phillips screwdriver, vacuum cleaner, broom, mop.
Construction steps of anti-static pvc floor
Carefully check the flatness of the ground and the verticality of the walls. If major defects are found or local reconstruction is required, it shall be proposed to relevant departments of Party A. Pull the horizontal line, use ink lines to bounce the installation height of the floor to the wall, ensure that the laid floor is on the same horizontal line, measure the length and width of the room and select the reference position, pop up the network grid of the installation bracket on the ground, ensure the neat and beautiful laying of the floor, and minimize the cutting of the floor; adjust the bearing to be installed to the same required height, and place the bearing at the intersection of the grounding grid line; fix the truss beam on the bracket with mounting screws, and correct the truss beam one by one with a level and a square ruler to make it In the same plane and perpendicular to each other; use a suction plate device to place the movable floor on the assembled truss beam; if the remaining size near the wall is less than the length of the movable floor, it can be repaired by cutting the floor; when laying anti-static pvc floor, use a level to level one by one. The height of the raised floor is adjusted by an adjustable bracket. During the laying process, care should be taken to prevent scratching the floor and damaging the side strips. At the same time, the laying should be cleaned to avoid debris and dust under the floor; When heavy equipment is set up in the machine room, bearings can be installed under the equipment base floor to prevent floor deformation. When the anti-static pvc floor needs to be cut or drilled, a crack hole should be opened at the concave corner of the opening to prevent the decorative surface of the processed floor from cracking.
Need to know morePVC floor stickers, 3D self-adhesive wall stickers, plastic floorThe content, can pay attention to us.